Sharpening a skiving or head knife
Skiving is the thinning of a piece of leather using a sharp tool.1 Head knives differ by maker, so check your maker's instructions for your model. Keep the edge straight. Keep the bevel flat.
What "true" means here
A bevel is the angled face that meets the cutting edge. "True" means that face stays flat and keeps the same angle along its whole length. If it rocks or rounds, the edge stops lying flat on the leather, and the cut wanders.
Keep the angle that's already on the blade. Don't change it without a reason.
In general, but not always, the harder the material to be cut, the higher (duller) the angle of the edge.2 Your blade's maker may state the angle it was ground to, so check the maker's own instructions for your model.
Before you start
Choose your stone with the help of the grit table. Then check that it's flat. A worn middle can curve the blade.3 A dip in the stone can show up as a rounded bevel.
Hold the stone steady on a damp cloth. Keep your free hand behind the edge.
Steps
- Wet the stone as its maker directs.
- Lay the blade so the bevel sits flat on the stone. You should feel it settle with no gap at either end.
- Lock your wrist and elbow. Move from the shoulder, so the hand doesn't tilt.
- Slide the blade along the stone, edge first, and keep the bevel flat on it for the whole stroke. For a long blade, work from one end of the edge to the other, a section at a time.
- Use the same number of light strokes on each section.
- Check for a burr, a thin wire of waste metal on the far side of the edge.4 Check by stroking from the spine toward the edge, never along it.
- When the burr runs the length of the edge, flip the blade and take a few strokes to lift it. Don't keep grinding past that point.
- Move to a finer stone if the blade needs it. Work from coarse to fine, never the other way round.2
- Strop lightly, as the last step.4 The method is on its own page.
Mistakes that spoil the bevel
- Rocking. Tilting the blade up and down between strokes rounds the bevel. Reset to flat each time.
- Pressing on the edge. Heavy pressure at one end leaves that end rounded.
- Over-grinding. Repeated sharpening will end up thickening the primary bevel.2
- Skipping the flat check. A hollow in the stone hollows the blade.
If you find a chip rather than general dullness, a coarse stone and more patience are needed. This page doesn't cover repairs, and the maker's instructions come first.
Handling
Cut away from your body whenever you use a skiving knife, and keep the blade covered between jobs. Never leave it loose on the bench. The safe handling page explains storage, and why blades go dull helps you decide when it's time to sharpen again.
Where the facts come from
- Skive (disambiguation), Wikipedia
- Knife sharpening, Wikipedia
- Sharpening stone, Wikipedia
- Sharpening, Wikipedia