Sharpening stones and grits for leather blades
Grit is a number printed on a stone. A low number cuts fast and leaves a rough edge. A high number cuts slowly and leaves a smooth one.
How grit numbers work
Sharpening stones come in grades that refer to the grit size of the abrasive particles. Grit size is given as a number, and a higher number means smaller particles and a finer finish.1 The numbers aren't tightly standardised. There is no dominant standard for the relationship between grit size and particle diameter.1 A stone from one maker may feel different from the same number made elsewhere.
Synthetic stones are available in precise grit ratings, ranging from coarse (for repairing chips) to extremely fine (for polishing).2
Typical grits and what they do
This table comes from a Wikipedia list written for steel knives in general. It isn't specific to leather blades.
| Grit | Typical use |
|---|---|
| 200 | Used for sharpening and defining the edge1 |
| 500 | Good for producing sharp edges1 |
| 1000 to 2000 | Fine, will leave a blade sharper than most factory edges1 |
| 4000 | Ultra-fine1 |
| 8000 | Further smoothing a sharp cut1 |
| 10000 | Polishing an edge to a mirror-smooth (but possibly fragile) finish1 |
That last note is worth a second look. A very polished edge can be fragile. Match the finish to the work.
The order to work in
Knife sharpening proceeds in several stages, in order from coarsest (most destructive) to finest (most delicate).3 For a leather blade, that gives a path like this:
- Coarse. Only for a chip, nick or badly worn edge. It's the most destructive stage, so leave it out if the blade doesn't need it.
- Medium. Sets a clean, even edge.
- Fine. Removes the scratches from the stone before it.
- Strop. Straightens and polishes. See how to strop.
Don't jump more than one step in coarseness at a time. A fine stone can't remove deep scratches from a coarse one quickly. That's practical advice, not a figure from a source.
Stone type matters too. A finer grain usually, though not always, produces sharper blades.3 Many stones come as a double-sided block with a coarse grit on one side and a fine grit on the other.1 That can cover the basics with one purchase of a stone, though this site doesn't recommend any make.
Lubricant and swarf
Stones need a lubricant, typically oil or water, to reduce friction and flush away swarf (metal filings).2 Whetstones are used with a cutting fluid to carry away swarf.1 Use whichever your stone's maker names, and don't switch a stone from oil to water or back without checking.
Keep the stone flat
Whetstones will wear away with use, typically in the middle. Tools sharpened in this groove will develop undesirable curves on the blade.1 On a leather knife that could change how the whole edge sits, so check the stone's surface before each session.
Power grinders
A bench grinder removes metal fast, but the friction heat generated can ruin the temper of the steel if not cooled carefully.2 If you use one, cool the blade often.
Once you've picked a stone, the next pages cover technique: sharpening a round knife and sharpening a skiving knife.
Where the facts come from
- Sharpening stone, Wikipedia
- Sharpening, Wikipedia
- Knife sharpening, Wikipedia