Skip to content

How to strop a leather knife, step by step

Up to date as of 20 November 2026

Stropping is the last step before you cut. It's quick, and it does the most good on an edge that's nearly sharp already.

What stropping does

A strop is a strip of leather, canvas or other soft material used to straighten and polish a blade. In many cases stropping re-aligns parts of the blade edge that have been bent out of alignment.1 It is a finishing step, and it removes little or no metal.2

That second point sets the limit. Stropping tidies a good edge. It won't rescue a blade that needs a stone. If the knife is rounded or nicked, start with why leather knives go dull to work out which problem you have.

Stropping is also the step that removes the burr, a thin wire of waste metal left on the edge by the stone.3

What you need

  • A strop. It may be a hanging strop, a block placed on a table or held in the hand, or a hand-held paddle.1
  • A way to hold it still. A strop that slides is how edges get cut or rounded.
  • Optionally, a polishing compound. The compound and strop types page covers the choices.

Steps

  1. Fix the strop on the bench, or clamp the paddle, so it can't shift while you work.
  2. Wipe the blade clean of dust and metal swarf. Grit on the strop works like a stone, and you don't want it there.
  3. Lay the blade's bevel flat on the strop. The bevel is the angled face that meets the edge. For a blade with a bevel on one side only, lay that side down.
  4. Lift the spine a hair, until the bevel just meets the surface. The smaller the angle, the sharper the knife will be, but the less side force is needed to bend the edge over.2 That's why a light hand matters.
  5. Pull the blade away from the edge, so the spine leads and the edge trails. Pushing the edge forward cuts into the strop.
  6. Keep the pressure light and the angle steady for the whole stroke.
  7. Turn the blade over and repeat on the other face, if it has a second bevel.
  8. Make a few strokes per side, then test on a scrap of leather. Stop when it cuts cleanly.
One stropping sessionFix the strop so it can't moveLay the bevel flat on the stropPull the blade edge-trailingFlip and repeat on the other sideTest on scrap leather
Short, light strokes, then check the edge.

Common ways to roll the edge

  • Lifting the spine too high. The angle gets steeper and the edge rounds off. Keep the same spine height on every stroke.
  • Pressing hard. A firm hand bends the edge over. Light is enough.
  • Flipping the blade with the edge leading. Roll the blade over its spine between strokes.
  • Stropping a blade that still has damage. It only polishes the fault.

Keep your hands safe

Pull away from your body, and keep your free hand behind the edge and off the strop's path. Cover the blade once you've finished. Safe handling lists the habits worth building.

When the strop stops helping, it's time for the stone. Stropping is the final step in many sharpening processes.3 Pick a stone first, then come back to the strop.

Where the facts come from

  1. Razor strop, Wikipedia
  2. Knife sharpening, Wikipedia
  3. Sharpening, Wikipedia