Sharpening a round knife on a stone
A round knife has a curved edge, and a flat stone touches only a short piece of it at a time. The job is to move the blade so every piece gets the same amount of work.
Before you start
First work out whether the blade needs a stone at all, using the dullness checks. A rolled edge may only need a strop. Pick a stone from the grits page, and follow the maker's instructions for oil or water.
Fix the stone on a damp cloth or in a holder so it can't slide. Check the stone for a dip in the middle. A groove worn into a stone can put undesirable curves on the blade.1 A curved blade run on a hollowed stone is hard to keep even.
Wear cut-resistant gloves if you own them, and keep your fingers behind the edge, never in front of it.
Steady angle, even work
A smaller angle gives a sharper knife. It also takes less side force to bend the edge over or chip it off.2 That's the whole trade. Pick one angle, the one the existing bevel already sits at, and hold it.
Finding that angle is simple. Lay the bevel flat on the stone until you can feel it sit with no gap. Then keep your wrist still. Most mistakes come from the wrist lifting during a stroke.
Steps
- Wet the stone with oil or water, as its maker directs. The liquid carries away swarf, the metal filings.3
- Set the knife on the stone with the bevel flat. If the bevel faces one side, that's the side down.
- Start at the heel, the part of the curve nearest the handle.
- Push the blade across the stone, edge first, as if you were slicing a thin layer off the stone's surface. At the same time, roll the knife slowly along its curve, so the contact point travels from the heel to the tip.
- Finish the stroke at the tip, lift cleanly, and return to the heel. Don't drag the edge backwards.
- Keep the pressure light, and use the same number of strokes before you stop to check.
- Feel for the burr, a thin wire of waste metal on the other side of the edge.3 Run a fingertip off the edge, away from it, never along it. If you can feel it all the way round, the first side is done.
- Turn the knife over. Work the second face, if it has one, until the burr has moved back the other way.
- Move to a finer stone if you have one. Sharpening runs from the most destructive stage to the most delicate.2
- Strop to finish. Stropping is the final step in many sharpening processes.3 The stropping steps cover it.
Common faults
- The heel is sharp and the tip isn't. The roll finished too early. Slow down near the tip.
- The tip is sharp and the middle isn't. The knife is rising off the stone halfway. Keep the wrist still and roll from the forearm.
- A flat spot shows on the curve. You've stopped rolling at one point. Start the stroke again from the heel.
- The bevel looks wider than it did. Repeated sharpening will end up thickening the primary bevel.2 A wide bevel needs more care than this page covers.
Safety
Put the knife down flat or in its sheath while you wipe the stone. Cover the edge when you've finished, and keep it away from children. Dry the blade fully before it goes into storage. The storage habits page has the rest.
Where the facts come from
- Sharpening stone, Wikipedia
- Knife sharpening, Wikipedia
- Sharpening, Wikipedia