Skip to content

Stropping compounds and strop types explained

Up to date as of 20 November 2026

A strop has two parts: a surface and, sometimes, a compound loaded onto it. They do different jobs, and you can choose each one separately.

Strop shapes

Three shapes turn up in the sources: hanging, block and paddle.1

Shape How it's used Points to weigh
Paddle Held in the hand or laid on a bench Flat and rigid, so the blade lies true
Block Sits on a table, or is held Stays put under the blade
Hanging strop Hung from a hook and pulled tight Needs tension from you, and a fixed point

Those notes are general handling points, not measured results. For a curved blade, a flat paddle or block is the simplest to hold steady. A hanging strop can sag under the blade and round the edge if you let it go slack.

Surfaces

A strop is a flexible strip of leather, canvas, denim fabric, balsa wood or other soft material.1 Wikipedia's sharpening page describes strops as a strip of leather or canvas, often charged with an abrasive polishing compound.2

Follow the strop maker's instructions on which surface to use.

What compounds do

Various abrasive compounds may be applied to the strop to aid in polishing the blade.1 A strop can be used clean or impregnated with abrasive compounds.3

The difference matters:

  • Clean strop. It straightens and burnishes. It removes little or no metal.3
  • Strop with compound. Especially when an abrasive polishing compound is used, stropping may remove a small amount of metal.1

Common abrasive compounds include diamonds, chromium oxide, aluminium oxide and iron oxide.1 A strop's leather may be coated with green chromium oxide polishing compound.3

Beyond that list, the sources here don't rank the compounds or give grit sizes for strops, so this page doesn't either. Read the maker's label for the compound you own. Follow it for handling, ventilation and storage, and keep the bar away from children.

Choosing a strop setupPick a shape: paddle, block or hangingPick a surface, following the maker's instructionsDecide: plain or with compoundKeep one compound per strop
Decide the shape first, then the surface, then the compound.

How to choose

  1. Start with the shape that gives you a firm, flat surface for your blade. A paddle or block suits most home benches.
  2. Follow the strop maker's instructions on the surface.
  3. Try a clean strop first. If the edge still needs polish, add a compound.
  4. Keep one compound on each strop. Mixing them leaves you unsure what the surface is doing.
  5. Clean the blade before stropping, so grit doesn't end up in the strop.

If you're starting from nothing, the step-by-step stropping method shows how the strop gets used. If the blade needs more than a strop can give, look at the stone guide.

When a strop can't help

Stropping won't remove a chip. It's a finishing tool. A very slightly reshaped or straightened edge is the limit.3 Use a stone for anything deeper.

Where the facts come from

  1. Razor strop, Wikipedia
  2. Sharpening, Wikipedia
  3. Knife sharpening, Wikipedia